[ Pobierz całość w formacie PDF ]

ÿþSPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
X
PETROL
RENAULT CLIO* 98 ’! DIESEL
’!
MAKE MOD. YEAR
* Models with original equipment keyless entry system.
ALARM/SIREN Position the compact alarms and the sirens in the engine compartment, on the shock
absorber, passenger s side. Position the modular systems and the modules behind the
POSITION
carpet, under the glove box. To route the cables, make a hole on the lower left of the
engine management unit connector in the windshield-wipers compartment.
POWER SUPPLY + 30: Connect to the 4 mm2 RED wire in the general supply wiring of the fuse box.
- 31: Connect to the 2 mm2 BROWN wire in the pink earth group, behind the left lateral
panel, driver s side.
IGNITION WIRE Connect to the 1 mm2 WHITE/RED wire located in the superior part of the fuse box, on
the left of the dashboard, driver s side.
DIRECTION INDICATORS Connect to the ORANGE wire at position C7 and BROWN wire at position D7 of the 27
way brown connector on the right hand side under the dashboard. Alternatively, connect
to the same wires at the indicator stalk.
ELECTRIC WINDOWS Positive control signal art. 1980)
Driver s window: cut the 2 mm2 GREY wire.
Passenger s window: cut the 2 mm2 ORANGE wire.
Left rear window: cut the 2 mm2 GREEN wire.
Right rear window: cut the 2 mm2 BROWN wire.
These connections are made on the front electric window switches and on the way out of
the connector of the front drivers door.
ALARM CONTROLS For Art. 0144 antitheft:
Connect the VIOLET/WHITE wire (0144) to the VIOLET wire at the position nr. 4 coming
out of the 8 way black connector located behind the great connector on the base of the
driver s side support. Connect the ORANGE/WHITE wire (0144) to the WHITE wire at the
position nr. 8, coming out of the 8 way black connector of the connector mentioned above.
Connect the VIOLET wire (0144) to the LIGHT BROWN wire at the position nr. 1 coming
out of the 5 way green connector of the on/off switch in the central tunnel and connect the
ORANGE wire (0144) to the GREY wire located at the position nr. 5 coming out of the
green connector, the same mentioned above.
IMMOBILISATION POINT Fuel pump: cut the 1,5 mm2 light BROWN wire (YELLOW) in the wiring harness located
on top of the instrument panel at the dashboard on the driver s side (pop off the upper
cover of the dashboard. Alternatively, connect the same wire to a multiway connector in
the fuse box.
STARTER +50: cut the 2 mm2 WHITE wire at the position A1 of the 28 way brown connector.
Alternatively, cut the 3 mm2 ORANGE wire in the 2 way grey connector under the
steering column.
BONNET SWITCH Install an additional switch on the headlamp support plate, near the left headlight, using
the original hole.
DOORS SWITCH Connect to the 1 mm2 PINK/GREY wire in the wiring harness that comes out of the
driver s door. Alternatively, connect to the wire at the position A2 of the 9 way black
connector in the fuse box.
BOOT SWITCH Connect to the 1 mm2 BLUE or VIOLET wire in the wiring harness that comes off the
back lamp.
recli98gbbt.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual. [ Pobierz całość w formacie PDF ]